Filter
Top Products
Troubleshooting
Have a problem? See the table below.
The Speedlite
does
not
detach
from
the
camera.
The
mounting
foot's
locking
pin
has
not
been retracted.
J>
Loosen the locking ring all the way before detaching the Speedlite. (p.9)
The Speedlite
does
not
fire.
flj}:
The batteries are installed in
the
wrong
orientation.
J>
Install the batteries
in
the correct orientation. (p.8)
4Jjl
The Speedlite's internal batteries are exhausted.
l~}
If
the flash recycling time
is
30 sec. or longer, replace the batteries. (p.8)
p>
Install the Speedlite's internal batteries even when you use
an
external
power source. (p.8)
Attach
the
Speedlite securely
to
the
camera.
j> Attach the Speedlite's mounting foot securely to the camera. (p.9)
The electrical
contacts
of
the
Speedlite and camera are dirty.
Wr
Clean the contacts. (p.9)
The slave
unit
does
not
fire.
The slave's wireless
selector
is
not
set
to
<
SLAVE
>.
lb·
Set it to <SLAVE>. (p.34)
The slave
unit
is
not
positioned
properly.
Place the slave unit within the master unit's transmission range. (p.35)
r>
Point the slave unit's sensor toward the master unit. (p.35)
The
power
turns
off
by
itself.
After
90
sec.
of
idle operation,
auto
power
off
took
effect.
iii>
Press the shutter button halfway or press the test firing button. (p.10)
The
entire
LCD panel blinks.
The
wide
panel has been
pulled
out
for
bounce
flash.
Retract the wide panel. (p.20)
48