Filter
Top Products
92
SHOOTING A SNAPSHOT
Selecting the Face Detection Method (Priority)
Use the following procedure to specify whether you want to give
priority to faster speed or a higher number of faces during face
detection.
1. Enter a REC mode.
2. Press [S] ( ) once.
3. Use [W] and [X] to select “ Priority” and
then press [SET].
4. Use [S] and [T] to select the setting you want,
and then press [SET].
NOT
E
• Selecting “Quantity” while using the Normal mode will
make it possible to detected smaller faces at a greater
distance than when “Speed” is selected.
Face Recognition Precautions
• The maximum number of faces that can be detected at one
time is five when “Speed” is selected for the “Priority” setting,
and ten when “Quantity” is selected.
• Detection of the following types of faces is not supported.
– A face that is partially obstructed by hair, sunglasses, a hat,
etc
– A face that is shaded from the light
– A profile of a face that is not shot straight on
– A face that is tilted left or right
– A face that is very far away or very small
– A face that is very close or very large
– A face in an area that is very dark
• Face detection is not supported for animals or other non-
human subjects.
• Even if you have the face of a family member recorded, the
person’s facial expression, shooting conditions, or other
factors can make proper recognition (highest priority
assignment) impossible.
• Face recognition can be improved by recording multiple
versions of the same person’s face indoors and outdoors, with
different expressions, and at different angles.
To do this:
Select this
setting:
Minimize face detection time. Up to five
faces can be detected.
Speed
Allow detection of a maximum of five to ten
faces.
Quantity