Filter
Top Products
CX Series Instruction Manual
Page 3
NOTES
A) Do not remove desiccant pack! There is a desiccant pack attached to
the housing base under the board camera that is designed to absorb any
moisture trapped inside the housing during adjustment. To avoid excessive
moisture buildup, it is recommended that the camera not be installed in rainy
or excessively damp conditions. It is also advisable to limit the number of times
the housing cover is removed. The desiccant pack can be replaced if
condensation develops inside the housing.
B) If the housing cover is opened frequently or if the gasket dries out, apply a light
coat of good quality silicone-based grease to the gasket to maintain a
watertight seal.
C) Make sure that the end of the cable, including BNC connector and power
connection, are not exposed to the elements. Exposed cable may cause a
power short.
FCC RULES: PART 15
This device can be expected to comply with part 15 of the FCC Rules, provided it is
assembled in exact accordance with the instructions provided with this kit. Operation
is subject to the following conditions: (1) This device may not cause harmful
interference; and (2) this device must accept any interference received including
interference that may cause undesired operation.