Filter
Top Products
SKU 93550
For technical questions please call 1-800-444-3353
. Page 4
Operation
This device must be powered to preserve the vehicle’s saved settings. You may use
a 12V battery or a 9V “radio” battery to supply this power (neither one included).
1. If using a 12V battery: connect the Red alligator clip to the positive (+) pole
of the battery and the Black alligator clip to the negative (-) pole of the
battery. Plug connector into the Jack on side to the tool. WARNING: 12V
lead/acid batteries can be very dangerous. Always wear safety gloves and
ANSI-approved safety goggles when working with 12V lead/acid batteries.
Do not allow battery to overheat.
If using a 9V battery: open the battery cover of the device, and install a new 9V
battery, attaching the battery plug to the battery. Close the battery compartment
cover.
2. Using either a spare 12V battery or an installed 9V battery, two green LED
lights will illuminate indicating the device has power. Do not short out the
12V Lighter adapter on a metal surface, it is now powered.
3. Be sure that vehicle ignition and all accessories, including lights, radio,
interior light, etc. are OFF Before using this device. If any powered item is
ON, the memory device may fail.
4. Press and hold the Red Button on the device while inserting the plug into the
vehicle cigarette lighter outlet.
5. One Green LED will now glow, indicating a good connection through the
vehicle cigarette lighter outlet.
NOTE: On some vehicles, the key must be left in the “Accessories” setting
for the cigarette lighter outlet to be active.
6. Release the Red Button. Both green LED lights will now glow indicating a
good connection.
7. You may now disconnect the vehicle 12V battery. Keep in mind that the
temporary power supply will only last as long as the battery used.
8. When the work is finished, reconnect the vehicle 12V battery.
9. Press and hold the Red Button on the Memory Saver while you remove the
Memory Saver device from the cigarette lighter outlet. Do not leave the unit
connected after use.
10. If a 12V Battery is used, carefully disconnect the Alligator clips from the 12V
battery, and unplug from Jack on side of tool.
REV 04/06