32
Installing the Operating System on the Cisco Unified Communications Server, Versions 2000.4.3 and 2000.4.3a
OL-10221-02
Error Messages
The installation was unable to detect the needed
state information!
This can be caused by a corrupted or incompatible
BIOS version.
Error code: <number>
Fatal Error
This message displays when the installation
cannot determine the necessary state information.
Attempt the installation again.
The installation was unable to reset needed state
information!
This can be caused by a corrupted or incompatible
BIOS version.
Error code: <number>
Fatal Error
This message displays when the installation
cannot change the state information. Attempt the
installation again.
The installation was unable to retrieve needed
system information!
Error code: <number>
SysInfo Fatal Error
This message displays when the installation
cannot determine the necessary system
information. Attempt the installation again.
The installation was unable to retrieve needed
drive information!
Error code: <number>
Drive Count Fatal Error
This message displays when the installation
cannot determine the number of hard drives.
Verify that the hard drives are functioning and
properly installed. Attempt the installation again.
The configuration of the array controller failed!
This can be caused by unexpected hardware or a
hardware failure within the system.
Error code: <number>
Fatal Error
This message displays when the RAID controller
failed to accept the configuration information.
Write down the error message in a place that you
will remember and attempt the installation again.
The transfer of the latest Security and System
Updates failed!
This can be caused by scratched or smudged
DVD-ROM media or missing files on the
DVD-ROM.
An internal error occurred. Attempt the
installation again.
The installation will now abort. This message displays at the end of any fatal error.
OS image complete. Now Rebooting... You do not need to take any action.
Table 6 Error Messages (continued)
Error Message Corrective Action