Filter
Top Products
2-9
Cisco Video Surveillance 5010/5011 Indoor Fixed HD IP Dome Camera User Guide
OL-22669-02
Chapter 2 Installation
Service Cable
Service Cable
The dome camera includes a service port that outputs camera video. Use it at the installation site to set
up the field of view and to focus the camera.
To assemble a service cable for the camera, you will need to purchase the following items from an
electronics supply store:
To assemble the cable:
Step 1 Attach the CPM 88 miniature coaxial connector to one end of the cable. Follow the directions supplied
with the miniature coaxial connector.
Step 2 Attach the 2.5 mm stereo plug to the other end of the coaxial cable (refer to Figure 2-12 on page 2-10):
a. Remove the support sleeve from the plug.
b. Slip the shrink fit tubing and support sleeve over the end of the cable.
c. Prepare the cable:
d. Strip back the outer jacket 0.318 inch (8.06 mm) inch from the end of the cable.
e. Pull back the coaxial braid shield.
f. Strip back the insulating material 0.125 inch (3.18 mm) inch to expose the center conductor.
g. Solder the center connector of the cable to the center pin of the plug.
h. Pull the coaxial braid shield back through the crimp pin and solder it to the top of the crimp pin arm.
i. Crimp the end of the crimp pin around the cable.
j. Heat the shrink fit tubing around the center conductor and shoulder pin.
k. Reassemble the support sleeve and the plug.
Qty Description
1 2.5 mm stereo plug (male)
1 CPM 88 miniature coaxial connector
1 RG174/U coaxial cable
1 1/8-inch shrink fit tubing, 1/2-inch long