Filter
Top Products
2-9
Cisco Video Surveillance 7030 IP Camera Installation Guide
OL-28692-01
Chapter 2 Camera Installation
Installing the IP Camera with a Vandal Resistant Enclosure
c. Rotate the IP camera to adjust the horizontal orientation until you achieve a level image.
Step 10 (Optional) If the IP camera is installed in a high humidity environment, remove the wrapper from the
included silica gel pack and place the pack with the camera inside the VR housing. Ensure that the silica
gel pack does not obstruct the IP camera field of view.
Step 11 Attach the dome cover to the camera by aligning it with the mounting holes.
Step 12 Use the included wrench and tighten the four dome cover screws to secure the dome cover to the camera.
Make sure all parts of the camera are securely installed.
What to do next
Complete the following procedures:
• After you install the IP camera, follow the instructions in the “Performing the Initial Setup of the IP
Camera” section on page 3-1 to access the IP camera through your network.