Filter
Top Products
4
Section 2
Getting Up and Running
Getting Up and RunningGetting Up and Running
Getting Up and Running
ϪLoading the Batteries
You must load 2 AA size alkaline batteries
before the camera can be used:
1. Press down and hold the release button,
and slide the battery/SD Card cover in the
direction of the arrow to release the cover.
2. Insert the batteries according to the correct
polarity marks (+ or -).
3. Close the battery/SD card cover firmly.
-
--
-
SD Card
+
++
+
Battery/SD
Card Cover
AA Size Battery
Release Button
-
--
-
SD Card
+
++
+
Battery/SD
Card Cover
AA Size Battery
Release Button
ϪInserting and Removing an SD Card (Optional)
The camera comes with 16MB of built-in memory, allowing you to store images and movie
clips. You can expand the memory capacity by using an optional SD (Secure Digital) memory
card. To insert a memory card, refer to the figure above and:
1. Open the battery/SD card cover.
2. Insert the memory card with the metal surface facing the front of the
camera.
3. Press the card into the slot until it locks into position.
To remove an installed SD card, press the card inwards to release it. When the card pops out,
gently slide it from its slot.
Release
button