D-Link DCS-1000W Digital Camera User Manual


 
11
Using the Internet Camera as a
Security System
D-Link's IP Camera System is one of the most cost effect
security solutions today. Both the DCS-1000 Wired model
and DCS-1000W Wired/Wireless model have input/output
controls for interfacing with security systems.
On the back of the Camera you will find an 8-position
connector. This connector has 2 input triggers for security
sensors and 2 output triggers for security alarms.
Security sensors for input are available as Passive (low-
current/low voltage) sensors or Active (powered) sensors.
Because of power limitations of the DCS cameras and its compatibility with Power over
Ethernet standards the sensor power requirement must be obeyed for proper operation.
We have listed Passive and Active components that will interface with the DCS family of
Cameras. Passive components must not exceed 5V 100mA. Active components must
be self-powered by an external power source.
For the demonstration below a D-Link DCS-1000 was purchased from www.dlinkshop.com
, the security equipment was purchased from www.smarthome.com, and some cable
accessories from a local hardware store.
Materials
DCS-1000
2 Ethernet Cables & Ethernet Switch/Internet Router
An Ethernet based PC to configure system
Internet Name Server and E-Mail Server to send capture information
10FT. 24Gauge
1 light current power distribution block for 12V power
30W Weatherproof Siren
High Sensitivity DPDT relay (allows 5V camera to turn on 12V siren)
Mini-Magnetic Contact Switch (commonly used for doors or windows)
PIR Motion Detector
You will need some simple tools like wire cutters/strippers and the appropriate screwdriver
for mounting and distribution block setup.
Everything less the camera cost about $97 US Dollars including shipping.