D-Link DCS-1000W Digital Camera User Manual


 
29
The default setting for the I/O Trigger functions is “disabled.” You must enable
the I/O Trigger first before the Triggers will perform.
There are two options to select from the Trigger screen I/O Input 1 Trigger
and I/O Input 2 Trigger.
I/O Input 1 Trigger:
Select “Send e-mail attached with image” and enter the relevant information
such as the SMTP Server Address, Sender e-mail Address, Receiver e-mail
Address, Sending Interval and Sending Times.
SMTP (Simple Mail Transfer Protocol) is a protocol for sending e-mail
messages between servers. You need to input the mail server address
in this field.
Sender e-mail is the person’s e-mail address that will be sending the
e-mail.
Receiver e-mail is the e-mail address of the person that will receive
the e-mail.
Sending Interval is the period of time between each e-mail being sent
to the receiver. If the setting is at 10 seconds, a new e-mail will be sent
in 10 seconds interval to the receiver.
Sending Time is the number of times the e-mail will be sent to the
receiver before it terminates.
Select “Trigger I/O Output” and enter the setting for the duration of the output
device for Output 1 time and Output 2 time in seconds.
I/O Input 2 Trigger:
Refer to “I/O Input 1 Trigger” information above.
Save/Cancel:
After making sure all settings in the System are correct, click on the “Save”
icon to store the settings for the Internet Camera. You can alternatively click on
the “Cancel” icon to restore all settings to the values last saved to or retrieved
from the Internet Camera.
Warning
Please refer to the appendix for detailed information regarding the I/O Connector.
When connecting other devices through the I/O connectors, please make
sure the maximum current of 100mA is strictly observed. Any failure to do
so might cause a loss of power and possibly cause serious damage to the
Internet Camera.