Filter
Top Products
Setting up your digital picture frame
9
Warning: There is a danger of explosion if the battery is not
replaced correctly. Replace with the same or equivalent type
battery.
To install a remote control battery:
1 Turn the remote control over to the back side.
2 Push the release tab to the right and pull the battery tray
out of the remote control.
3 If this is the first time you will be using the remote control,
remove the insulation sheet that covers the battery.
-OR-
If you are replacing the battery, remove the old battery and
insert a new lithium coin cell battery (CR2025) into the
battery tray. Make sure that you match the + symbol on
the battery with the + symbol on the battery tray.
09-0442 DX_DPF7-10_MAN_ENG_V1.fm Page 9 Tuesday, July 7, 2009 3:00 PM