Filter
Top Products
4-3
A
B
4
Storing Pictures
You need to remove the CompactFlash memory card from
the camera before you can use its internal memory to store
images. (See page 1-10 for instructions.) You can increase
your camera’s storage capacity by replacing the 8MB
CompactFlash card with a larger one. See Appendix A in
your User’s Guide for more information.
The camera holds the following numbers of pictures in each
image quality mode:
NOTE
You can mix pictures of varying quality in the camera; the
camera’s image capacity will vary accordingly. Depending on the
content of your pictures, your camera may hold more than the
numbers shown above. As long as the display panel shows a
number other than zero, you can continue taking pictures.
Using the Flash
The camera’s built-in flash is effective within a range of
8 inches to 8 feet (20 cm to 2.3 m). Press the flash button to
cycle through the three flash settings.
An icon for each setting appears on the display panel as
shown below:
Auto
The flash goes off automatically whenever it’s needed
for adequate lighting (factory setting).
Camera’s 4MB
Internal
Memory
8MB Lexar
Media Memory
Card
Total for 12MB
Internal
Memory and
8MB Card
Standard
50 128 178
Fine
15 39 54
Super Fine
71926
HyPict
41216
GetStart.book Page 3 Tuesday, March 2, 1999 5:13 PM