Filter
Top Products
- 14 -
2.2.2 Adjusting Zoom and Focus
It is highly recommended to use an EverFocus Test Monitor to set up the camera. Find the Video test
connection on the back of the camera module. Connect using the video cable included in the package.
1. Loosen the zoom ring knob, and then turn the ring towards <W> or <T> as necessary to obtain the
desired view angle.
W side (Zoom out)
The viewing range will be wider and the subject is smaller.
T side (Zoom in)
The viewing range will be smaller and the subject is larger.
2. Loosen the focus ring knob, then turn the ring towards <∞> or <N> as necessary to obtain a clear
video image.
3. Repeat steps 1 and 2 until the best image is obtained. Once the lens setting is complete, tighten
the zoom and focus ring knobs.
Important Note when focusing a 9-22mm Lens
To adjust lens zoom and focus, if using the 9~22mm lens model ED610 camera, the focus aiding lens
cap must be used to simulate the dome being closed. Follow the steps below to ensure that camera
will stay in focus when the dome is installed.
Step 1 Take the included focus aiding lens cap (shown below) from its small plastic bag.
Video out
Connect with Test Monitor