Filter
Top Products
- 26 -
COLOR: The picture is always displayed in color, even at low light levels.
AUTO: The picture switches to color in a normal (bright) environment and switches to B/W
when the ambient illumination is low. The switching point is determined by the AGC level.
Note: AGC selection must be set as middle or high in order to employ the auto
switching function.
Delay: Set the switchover delay time from 0~63 seconds.
S-Level: Set the start level from 0~100.
E-Level: Set the end level from 0~100.
EXT:
The picture switches to color in a normal environment and switches to B/W when the ambient
illumination is low. The switching condition is determined by the light sensor alongside the lens.
3.7 3DNR
3DNR reduces the background noise in a low luminance environment.
OFF:
Disables 3DNR to keep the same amount of noise.
ON:
Enables 3DNR to reduce the noise.
Level: adjust noise reduction level from 0~100.
Return: Select “RET” to save all settings in 3DNR menu and returns to the previous
menu.
Select “END” to save all the menu settings and exit from the OSD menu.
3.8 SPECIAL
In this section, user can control special settings including Cam Title, D-Effect, Motion, Privacy, Sync,
Language and Return.
1. Please direct the arrow to point to “SPECIAL” on the SETUP menu by moving the joystick UP and
DOWN.
2. Select the mode you would like to operate by moving the joystick LEFT or RIGHT.
3.8.1 CAM TITLE
Input a camera title and it will be displayed on the monitor.
1) Please direct the arrow to point to “CAMERA” by moving the joystick UP or DOWN.
2) Select “ON” by moving the joystick LEFT or RIGHT.
3) Press in on the joystick.
4) Maximum 15 letters can be used for the ID.
Moving the joystick UP and DOWN position the cursor on the letter to be chosen.
Press in on the joystick to lock in the letters. Repeat as necessary.
5) Once a name has been selected, please choose a position where you would like to
display the name.
Move the cursor onto “POS” and press in on the joystick.
The name will appear at the top left hand corner.
Angle the joystick in any direction to select the desired position to display the
name. Press in on the joystick to lock in the position.