Filter
Top Products
17
8. Connect RG59 coaxial cable with BNC connector.
9. Unscrew both cable clips, wire power cable and RS485 cable through the cable clips. Then,
screw the cable clips to rear panel.
a. Connecting Power-24VAC model: connect 24VAC power on N and L
100VAC~240VAC Model: Connect PE, N and L.
*Warning*
To prevent electrical shock, turn off the electrical power before making electrical
connections.
Do not connect high voltage power to the camera. It may damage the camera.
Do not short circuit the power leads and expose the wire when connecting the power
supply to the camera.
b. Connect Video- Make sure connecter is firmly connected.
c. Connecting RS485 (optional): Connect RS585 cable to 485+ and 485-. Please use
screw driver to lose and tight the screw on the RS485 terminal pin when you do
connection.
10. Close the back cover and screw the 2 screws firmly. Now, you are done with the installation.
NOTE: Before you close the cover, please make sure control key is attached firmly and wire
doesn’t stuck.
Coaxial cable
Cable Clips
Power cable
RS485 cable
Cable Clips