FujiFilm 16317065 Digital Camera User Manual


 
vii
For Your Safety
• Do not mix old and new batteries, batteries
with different charge levels, or batteries of
different types.
• If the camera will not be used for an
extended period, remove the batteries.
Note that the camera clock will be reset.
• The batteries may be warm to the touch
immediately after use. Turn the camera
off and allow the batteries to cool before
handling.
• Battery capacity tends to decrease at low
temperatures. Keep spare batteries in a
pocket or other warm place and exchange
as necessary. Cold batteries may recover
some of their charge when warmed.
• Fingerprints and other stains on the battery
terminals can impair battery performance.
Thoroughly clean the terminals with a
soft, dry cloth before inserting them in the
camera.
If the batteries leak, clean the battery
compartment thoroughly before
inserting new batteries.
If fluid from the battery comes into
contact with skin or clothing, flush
the affected area with water. If fluid
enters your eyes, immediately flush
the affected area with water and seek
medical attention. Do not rub your eyes.
Failure to observe this precaution could
result in permanent visual impairment.
NiMH Batteries
The capacity of Ni-MH batteries may be
temporarily reduced when new, after long
periods of disuse, or if they are repeatedly
recharged before being fully discharged.
This is normal and does not indicate a
malfunction. Capacity can be increased by
repeatedly discharging the batteries using
the discharge option in the camera setup
menu and recharging them using a battery
charger.
Q CAUTION: Do not use the discharge option
with alkaline batteries.
The camera draws a small amount of current
even when off. Ni-MH batteries that have
been left in the camera for an extended
period may be drawn down to the point
that they no longer hold a charge. Battery
performance may also drop if the batteries
are run down in a device such as a flashlight.
Use the discharge option in the camera setup
menu to discharge Ni-MH batteries. Batteries
that no longer hold a charge even after
repeatedly being discharged and recharged
have reached the end of their service life and
must be replaced.
Ni-MH batteries can be recharged in a battery
charger (sold separately). Batteries may
become warm to the touch after charging.
Refer to the instructions provided with
the charger for more information. Use the
charger with compatible batteries only.
Ni-MH batteries gradually lose their charge
when not in use.
Disposal
CAUTION: Dispose of used batteries in accord
with local regulations.
AC Power Adapters (Available Separately)
AC Power Adapters (Available Separately)
This section applies to all camera models.
Use only FUJIFILM AC power adapters
designated for use with this camera. Other
adapters could damage the camera.
• The AC power adapter is for indoor use only.
• Be sure the DC plug is securely connected
to the camera.
• Turn the camera off before disconnecting
the adapter. Disconnect the adapter by the
plug, not the cable.
• Do not use with other devices.
• Do not disassemble.
• Do not expose to high heat and humidity.
• Do not subject to strong physical shocks.
• The adapter may hum or become hot to the
touch during use. This is normal.
• If the adapter causes radio interference,
reorient or relocate the receiving antenna.