Filter
Top Products
59
TROUBLE SHOOTING
During operation
1 Replace the battery with a new one.
2 Press the POWER button.
3 The flash is charging. Wait until “
” stops blinking
and is displayed. (The flash takes approximately 6
seconds to charge.)
4 Remove the film, and load an unexposed roll.
5 Photograph at 0.5 - 1.0 m (1.6-3.3 ft.) or use the
AF lock so that the AF lamp is lit.
● Remove the battery momentarily, then reload it.
1 Pull the end of the film out to the FILM TIP mark
and correctly load the film.
2 A picture can not be taken by pressing the shutter
release button in that condition. Open the camera
back a little and close it again.
● Be sure not to move the button while film is
loaded in the camera.
17
16
30
23
56
35
23
17,24
37
1 “
” symbol is blinking.
2 Power switch is not on.
3 Is “
” blinking on the LCD?
4 “
” is lit on the exposure counter.
5 Is the AF lamp blinking in the
mode?
● Did you remove film without rewinding
it after you began photographing?
1 Did you pull the end of the film out to
the FILM TIP mark when loading the
film?
2 Did you insert the battery after loading
the film?
● Did you operate the button in the
middle of the film?
The shutter release won’t
trip.
The numerals on the ex-
posure counter blink.
After loading the film it re-
wound immediately.
After loading the film and
closing the camera back,
the exposure counter does
not advance.
The film rewound during
photographing.
Problems Possible Causes Solutions Page