Filter
Top Products
113
Troubleshooting
Warning Messages and Displays
The following warnings are displayed in the monitor:
Warning
Warning
Description
Description
Solution
Solution
B (red) Batteries are low.
Insert fresh or fully-charged spare batteries.
A (blinks red) Batteries are exhausted.
k
Slow shutter speed. Picture may be blurred. Use the ash or mount the camera on a tripod.
s
(displayed in red
with red focus
frame)
The camera can not focus.
• Use focus lock to focus on another subject at the
same distance, then recompose the picture (pg. 33).
• If the subject is poorly lit, try focusing at a distance of
about 2 m (6.6 ft.).
• Use macro mode to focus when taking close-ups.
Aperture or shutter
speed shown in red
The subject is too bright or too dark. The pic-
ture will be over- or under-exposed.
If the subject is dark, use the ash.
BLINK DETECTED A subject or subjects may have blinked. Retake the photograph if desired.
FOCUS ERROR
Camera malfunction.
Turn the camera o and then on again, taking care not
to touch the lens. If the message persists, contact a
FUJIFILM dealer.
TURN OFF THE CAMERA
AND TURN ON AGAIN
LENS CONTROL ERROR
CARD NOT INITIALIZED
The memory card is not formatted or the
memory card was formatted in a computer or
other device.
Format the memory card using the
K FORMAT op-
tion in the camera setup menu (pg. 99).
The memory card contacts require cleaning.
Clean the contacts with a soft, dry cloth. If the mes-
sage is repeated, format the memory card (pg. 99). If
the message persists, replace the memory card.
Camera malfunction. Contact a FUJIFILM dealer.
PROTECTED CARD The memory card is locked. Unlock the memory card (pg. 10).