Filter
Top Products
17
1 Hold the film at an angle and place it in the camera.
2 Press the film until you hear a clicking sound. This indicates the film cassette is
seated properly.
3
4
A
2
1
A : FILM TIP mark
While holding the film cassette in place, gently pull the end of the film leader out as
far as the FILM TIP mark in the camera.
∗
Hold the film cassette down so that it does not pop out of the film compartment.
∗
Make sure the end of the film is correctly threaded onto the spool.
∗
If you should pull the film out too far, remove the film cassette and rotate the longer end of the
spool slowly to rewind some of the exposed film and adjust the leader to the correct length to
reach the FILM TIP mark. Be careful not to rewind the leader completely into the cassette.