Filter
Top Products
Page 2SKU 95153
For technical questions, please call 1-800-444-3353
SPECIFICATIONS
Batteries Required 2 “AA” Batteries (sold separately)
Overall Dimensions 4-1/8” X 11-3/4” L X 4-5/16” H
Dimensions
Bracket - 7” High
Base - 3-1/2” Diameter
Weight 2 lb.
Features 0-90° Up or Down Tilt, Continuous Blinking LED
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instruc-
tions, operating and maintenance procedures, parts list and diagram. Keep your invoice with
this manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
SAFETY WARNINGS AND PRECAUTIONS
WARNING: When using this product, basic safety precautions should always be followed
to reduce the risk of personal injury and damage to equipment.
Read all instructions before using this product!
Keep work area clean and well lit. 1. Cluttered areas invite injuries.
Observe work area conditions. 2. Do not use the Imitation Camera in damp or wet loca-
tions. Don’t expose to rain. Do not use electrically powered products in the presence
of flammable gases or liquids.
Keep children away. 3. Children must never be allowed in the work area. Mount the
Imitation camera out of children’s reach. This product is not a toy.
Use the right product for the job. 4. Do not modify this product and do not use this
product for a purpose for which it was not intended.
Dress properly. 5. Protective, electrically nonconductive clothes and nonskid footwear
are recommended when working. Wear restrictive hair covering to contain long hair.
Always wear ANSI-approved impact safety goggles and heavy-duty work gloves 6.
during installation or service.
Stay alert. 7. Watch what you are doing, use common sense. Do not install the Imitation
Camera when you are tired.
Check for damaged parts. 8. Before installing the Imitation Camera, any part that ap-
pears damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for any broken parts or mounting fixtures and
any other condition that may affect proper function. Any part that is damaged should
be properly repaired or replaced by a qualified technician.