Harbor Freight Tools 95153 Digital Camera User Manual


 
Page 5SKU 95153
For technical questions, please call 1-800-444-3353
BATTERY INSTALLATION
Warning: Only install batteries of the same type and charge level. Replace both
batteries at once. Install batteries according to polarity markings.
FIGURE 3
Batteries (9)
Sun-Visor (6)
Battery Cover (8) and Battery Cover Screws (5)
1. Remove the two Battery Cover Screws (5) from the Battery Cover (8) with a screwdriver
(sold separately). See Figure 3.
Slide the Battery Cover (8) off the Battery Case (11).2.
The Battery Case (11) is inside the Rear Housing (7). 3.
CAUTION: The housing and other machined parts of this item may have sharp
burrs that can cut you. Use care when changing the batteries.
Carefully remove the Batteries (9) from the Battery Case (11).
If present, remove old batteries and dispose of or recycle them properly.4.
Carefully place two new “AA” Batteries (9) into the Battery Case (11). Be sure that the 5.
polarities (+ or -) of the batteries line up with the polarity signs.
Carefully replace the Battery Cover (8). Insert the Battery Cover Screws (5) and tighten 6.
them with the screwdriver.
Check LED light. If it does not light, repeat the steps or replace the batteries with new 7.
ones.
Rear Housing (7)
Battery Case (11)