Filter
Top Products
10
HNC300
This section describes the externally visible features of the HNC300.
Front Panel
Power LED
The “Power” LED is located to the right of the camera’s lens (when facing the camera). A steady blue light confirms that
the camera is powered on.
Note:
The “Power” LED has three settings with which to control the light illumination while monitoring: Normal / Off /
Dummy. Please refer to the “Web Configuration” section for detailed information and usage.
Link LED
The “Link” LED is located on the far right side of the network camera’s lens (when facing the network camera). It is
located to the right of the “Power” LED. A steady orange light confirms a good connection. Depending on the data
traffic, the LED will begin to flash to indicate that the camera is receiving/transmitting from/to the network.
Note:
The “Link” LED has three settings with which to control the light illumination while monitoring: Normal / Off /
Dummy. Please refer to the “Web Configuration” section for detailed information and usage.
Power LED
Link LED