Filter
Top Products
Chapter 7: Troubleshooting and support 77
The wrong
date and/or
time is
shown.
The batteries
died or were
removed from
the camera for
too long.
The date and time will be
maintained for about 10 minutes
without batteries installed. Reset
the date and time by using the
Date & Time option in the Setup
menu. (See page 68, 68)
The camera
does not
respond
when I press
a button.
The camera is
turned off or
has shut down.
Turn on the camera, or turn it off
and then on again.
The camera is
connected to a
computer.
Most of the camera buttons,
except for the
switch,
do not respond when the camera
is connected to a computer. If they
respond, it is only to turn the
Image Display on if it is off, or, in
some cases, turn the Image
Display off if it is on.
The batteries
are drained.
Replace or recharge the batteries.
Images in the
memory card
may be
corrupted.
Remove the memory card.
The camera
has stopped
operating.
Reset the camera by holding the
switch in the ON
position until the Image Display
turns on.
Problem Possible cause Solution