Filter
Top Products
20
#
ACC_MACROS c:\pmis\Macros\Norway
#
#
# Location of the image storage media top directory: ACC_STORAGE_MEDIA_DIR
# (when s1 is set in sequence files)
# MARK: This directory must exist
# The images are stored in this directory tree.
#
ACC_STORAGE_MEDIA_DIR c:\data\images
#
#
# Type image file name created: ACC_LONG_IMAGENAME
# When LONG_IMAGENAME is 1 the long version of the file names are used
# When LONG_IMAGENAME is 0 the short version of the file names are used
#
# MARK: The version 3.5 of the PMIS software only acceps DOS
# compatible file names (8 + '.' + 3 characters).
# Therefore the ACC_LONG_IMAGENAME has to be 0
#
ACC_LONG_IMAGENAME 0
#
#
# Location of the directory on network disk where images are stored
# (when u1 is set in sequence files)
# In order for the images to be stored at network disk the
# operator must set 1 after ACC_NET_IMAGE_ALLOW
# In order to inhibit the storage of images at the network disk the
# operator must set 0 after ACC_NET_IMAGE_ALLOW
# When this option is used:
# In the ACC_NET_IMAGE_DIR directory the
# sub directories 427.8nm , 557.7nm and 630.0nm must exist.
#
# When the ACC_NET_IMAGE_DUMMY is 1 the dummy file dummy.dat is
# copied to the network image directory after the image
# is copied to this location.
#
ACC_NET_IMAGE_ALLOW 1
#ACC_NET_IMAGE_DIR g:\tmp\pmis\images
ACC_NET_IMAGE_DIR c:\tmp\images
ACC_NET_IMAGE_DUMMY 0
#
#
#
# ACC_NET_INFO_ALLOW
# Location of the INFO.ACC file . The INFO.ACC file contains the
# same information as the text written in the information window
# in ACC. This file is created only if ACC_NET_INFO_ALLOW is 1
#
ACC_NET_INFO_ALLOW 0
ACC_NET_INFO_DIR g:\tmp\acc\info
#
#
# The ACC2 program needs to check if the time intervals
# set in the TIMER files are reached.
# It also needs to check the GPS if the PC clock is to be changed
# Which second in the minute the RUN and TIMER files are checked
# is the ACC_CONTROL_SEC .
#
# ACC_USE_CONTROL_SEC = 1 use the ACC_CONTROL_SEC second in minute
# ACC_USE_CONTROL_SEC = 2 use the c# in sequence file, i.e. control after
# an image capture
ACC_USE_CONTROL_SEC 2
ACC_CONTROL_SEC 57
#
#
# If the GPS receiver should be used or not : ACC_USE_GPS
# 0 : no do not use the receiver
# 1 : yes use the receiver, program stops if receiver is not on
# 2 : yes use the receiver, program continue if receiver is not responding