HP (Hewlett-Packard) E330 series Digital Camera User Manual


 
Date & Time Imprint—Imprints date in lower left corner of pictures only. The setting
remains in effect until it is changed, even when you turn off the camera.
Off (Default)—No date or time imprinted on the image.
Date Only—Date permanently imprinted.
Date & Time—Date and time permanently imprinted.
Camera Setup...—Displays the Camera Setup Menu for setting camera behavior
(see Using the Camera Setup Menu” on page 25).
Camera Help...—Displays a list of help topics for commonly used features.
NOTE: Some menu options are not available in certain shooting modes.
Using the Self-Timer setting
The Self-Timer allows you to take an image or video clip 10 seconds after pressing
the Shutter button.
1. If you want to record a video clip or change the shooting mode, access the
Picture
Capture Menu, use
to highlight Shooting Mode, press , highlight either
Video or another shooting mode, press , then press to return to the
Picture Capture Menu.
2.
In the
Picture Capture Menu, use to highlight Self-Timer, press ,
highlight On, press
, then hold down until the menu disappears.
3. Set the camera on a tripod or stable surface.
4. Frame the subject in the Image Display or the viewfinder.
5. Press the Shutter button all the way down. The camera begins the 10-second
countdown, then takes the picture or begins recording the video clip.
6. If you are recording a video clip, press the Shutter button to stop recording.
The
Self-Timer setting resets to Off after the image is taken.
Using the Burst setting
Burst allows you to take up to two pictures as quickly as possible when you press
and hold the Shutter button all the way down.
1.
While in the
Picture Capture Menu, use to highlight Burst , press
, highlight On, press , then hold down until the menu disappears.
2. Frame the subject, then press the Shutter button all the way down and hold it. The
camera takes up to two pictures as quickly as possible until you release the
Shutter button or the camera runs out of memory.
The Image Display remains off during the burst capture. After the burst images have been
taken, each image appears one at a time in Instant Review (see
Instant Review”
on page 9). You can delete the entire burst sequence in Instant Review. To delete
individual images, see
Deleting images” on page 14.
The
Burst setting remains in effect until it is changed again, or until it resets to the
default Off setting when you turn off the camera.
Chapter 3
(continued)
12 Setting options for taking pictures and recording video clips