Filter
Top Products
Getting Started - 21 -
Note: Use only "AA" alkaline batteries marked "LR6". (Manganese batteries cannot be used
to power the camcorder.)
Note: It is recommended that you use alkaline batteries within the recommended period of
use or within two years of the date of manufacture.
Note: Be careful of the following to prevent the leakage of liquid or an explosion.
• Check that the orientation (polarity) of the batteries is correct.
• Remove the batteries when not using the camcorder.
• Remove the used batteries from the camcorder.
• Do not use batteries made by different manufacturers at the same time.
• Do not use old and new batteries at the same time.
Note: If the liquid leaks, remove the batteries immediately and ask your nearest dealer to
inspect the camcorder (this will be at your own expense).
Note: Do not let the batteries or the terminals of the camcorder get dirty. If they are dirty, use
a dry cloth to wipe off the dirt completely.
Note: It is recommended that you use a battery pack to power the camcorder when using a
DC camera light. If a camera light is used when the camcorder is powered by batteries, the
required supply voltage will be very short and the camcorder will turn off soon.
Note: When the batteries are used to power the camcorder in a cold place, it may not
operate normally; the operation time may become extremely short or the camcorder may not
be turned on. It is recommended that you use a battery pack to power the camcorder in a
cold place. (At 50°F (10°C), the chemical reaction decreases the capacity of battery to one-
tenth when compared to that at normal temperature 68°F (20°C).)
Note: Noise may appear momentarily in the viewfinder when recording is started or stopped.
Note: Be careful when touching the batteries with your bare hand to remove them as they are
warm during and just use.
Note: Since the supply voltage from batteries decreases more abruptly when compared to
that from a battery pack, the battery remaining level indicator ( ) may not flash in the
viewfinder, noise may occur, the picture and sound may not be recorded normally and/or the
power may be turned off soon. These phenomena occur because the capacity of batteries
becomes low. So turn the power switch off and replace the batteries. If the power switch is
left turned on in this state, the power may turn on temporarily and turn off again repeatedly.
Note: Be sure not to short, disassemble, heat or throw batteries into fire. This is very
dangerous.
Using Alternative Power Sources
Using the AC Adapter/Charger
Please ensure that the CAM/OFF/VIDEO switch is in the OFF position whenever attaching or
detaching any power supply (ie. battery, AC adapter/charger, etc.)