Honeywell HD4D Security Camera User Manual


 
Document 800-00023 Rev D 13
05/07
Adjusting the Camera
To adjust the HD4D Camera:
1. Apply 12 VDC or 24 VAC power to the camera and monitor the video signal.
2. Loosen the screws that lock the gimbal assembly in place (see Figure 5).
3. Adjust the camera carrier to the desired view.
4. Tighten the screws to lock the gimbal assembly in place.
Note Orient the camera as shown in Figure 5 to maintain the correct picture
orientation.
Figure 5 Gimbal Adjustment
Legend
A = Tilt rotation
B = Horizontal rotation
C = Pan rotation
Angle viewTop view
Setscrews (x2). Loosen to
adjust Pan (C). Other
setscrew located on
opposite side.
B
C
A
Locking screw
Line Lock switch
must be left in
ON position.
Locking screw. Loosen to
adjust Horizontal (B).
Set focus
(top)
Set focal length
(bottom)