Honeywell HD4UX Security Camera User Manual


 
Document 800-00031 Rev A 9
04/08
Connecting Cables Through the Housing Base
For installations that require pulling cables through the grommet located in the bottom of the
base:
1. Use a sharp knife to cut an ! opening in the base gasket (see Figure 1). Be careful. The
opening should be only big enough to feed the cable assembly through.
2. Pull the cabling through the opening.
3. Apply appropriate sealant around the opening to prevent moisture from entering the
housing.
Figure 1 Cable Connection Through Grommet
Base gasket opening
!