Filter
Top Products
22
Camera does not
take a picture
- Install a fully charged battery.
- If using a “lever type” zoom control, make sure the
control is centered and not engaged.
- There is not enough available light for the camera
to properly focus. Add a focusing light or strobe
with a built-in focusing light to your system.
- Select macro mode when shooting close-ups.
Problem
Solution
Fogging occurs on
the Lens Port
- Humid air is trapped inside the housing.
The camera produces heat and may condense
any trapped moisture forming fog on the lens port.
Close the housing in an air-conditioned room or
vehicle, or in front of an air-conditioner.
- The housing should not be direct in sunlight for an
extended period of time.
- Purchase desiccant packs also known as
moisture munchers from a local camera store.
Place one or two packs in your housing before
each day of diving.
- If moisture or water droplets are present around
the controls or sealing areas, return the housing
to Ikelite for evaluation.
- Clean the main housing o-ring and sealing
surface of the housing.
- Make sure the camera is mounted properly on the
camera tray and housing controls are out of the
way.
- Main housing o
-ring is not seated properly.
Housing is hard to
close