Ingersoll-Rand VL2-150 Digital Photo Keychain User Manual


 
10 MHD56012 - Edition 8
(Dwg. MHP0043)
Attaching End of Load Chain
Refer to Dwg. MHP0410 on page 10.
1. Push end pin (20) “in”, towards end spring (19). Remove end
anchor A (21).
2. Slide end link of load chain (47) on end anchor A (21) shaft.
3. Place end anchor A (21) shaft into end anchor B (22) guide
hole.
4. Reinstall end anchor A (21) on end pin (20). Depress and
align end pin (20) in side plate 1 (1) hole. When released end
pin (20) should spring into position and slide into hole in side
plate (1). Ensure load chain (47) is not twisted, kinked or
“capsized.” Refer to Dwg. MHP0043 on page 10.
5. Connect other end of load chain (47) as described in
“Installing New Load Chain” section.
Brake Adjustment
1. Unscrew nuts (40) and remove wheel cover (38) so that
handwheel (31) is exposed.
2. Remove cotter pin (34) and tighten pinion nut (33)
(clockwise). Hold load chain (47), if necessary, to keep
pinion shaft (13) from rotating.
3. Back off pinion nut (33) approximately 1/8th of a turn
(counterclockwise) and reinsert cotter pin (34).
Overload Clutch Adjustment
1. Suspend the VL2 hoist.
2. Remove wheel cover (38), cotter pin (34), pinion nut (33) and
washer (32).
3. Apply adjusting load shown in Table 3 to hoist.
4. Remove all slack from load chain.
5. Pull on hand chain to lift load approximately 2 feet (0.6 m)
off the floor.
6. Using overload clutch adjusting socket part number
71112064 (refer to Dwg. MHP0225 on page 10) adjust
overload clutch to required setting.
a. Tightening nut (82) will increase clutch overload limit.
b. Loosen nut (82) to decrease clutch overload limit.
Overload clutch should begin to slip with loads shown in
Table 3.
7. When desired clutch overload limit has been achieved bend
one of the outer tabs on washer (81) into a slot in nut (82).
Install washer (32) and pinion nut (33).
8. Tighten pinion nut (33).
(Dwg. MHP0410)
• Proper adjustment of overload clutch requires use of a
special tool (Part Number 71112064). Refer to Dwg. MHP0225
on page 10.
(Dwg. MHP0225)
Table 3: Overload Clutch Test Loads
Model No.
Adjustment Load (150% of rated capacity)
lbs.
kgs.
VL2-005 1,650
750
VL2-010 3,300
1,500
VL2-015 4,950
2,250
VL2-020 6,600
3,000
VL2-030 9,900
4,500
VL2-050 16,500
7,500
VL2-080 26,400
12,000
VL2-100 33,000
15,000
VL2-150 49,500
22,500
*VL2-200 33,000 each hoist
15,000 each hoist
* Each hoist body must be tested separately.