Filter
Top Products
Page 12
TM-6760 Series Progressive Scan Shutter Cameras
Installation
When wiring the PD-12UU power supply directly, please note the following:
• The lead ends must be twisted together and tin-soldered for strength and electrical continuity.
• Shrink tubing or a similar insulator should be used to prevent exposed leads from touching and
shorting.
• The +12V lead is marked with a red stripe or white lettering; be sure not to reverse the leads.
• All connections must be properly insulated to prevent shorting.
2.2.7 (b) JAI, Inc. Power Cables
If you are using JAI, Inc. power cables such as the 12P-02S, please refer to the 12-pin connector pin-out
diagram in “12-Pin Connector (TM-6760)” on page 6. The cable pin-out diagram is shown in Figure 7
below. The color-coded leads use Gray for Ground and Yellow for +12V.
FIGURE 7. 12P-02S Interface Cable (optional)
Note: Make sure that the unused leads are not touching and that there is no possibility that
exposed wires could cause the leads to short.
2.2.8 Attaching the Analog Video Output
When connecting the TM-6760 to an analog framegrabber or a monitor, use the BNC connector on the
rear panel of the camera. The input of the monitor should be balanced for 75 ohm termination. Standard
RG-59 type coaxial cable should carry a full video signal for up to 100 feet.
The multi-conductor cable 12P-02S from JAI, Inc. can be used to transmit analog video, power, sync.
signals, and serial communication. The mini coaxial leads in JAI, Inc. multi-conductor cables are
designed for short runs of no longer than 100 feet.
Note: Make sure that no extraneous wires are visible which could cause a short.
12P-02S Interface Cable
Pin# Lead Color Function Pin# Lead Color Function
1 Gray GND 7 Black coax VD Input
2 Yellow +12V DC 8 White coax shield Reserved
3 Red coax shield GND 9 White coax HD Input
4 Red coax Video 10 Brown RXD
5 Orange coax
shield
GND 11 Blue Integration
6 Orange coax VINIT IN 12 Black coax shield TXD
HD In (White Coax)
Video Out (Red Coax)
VD In (Black Coax)
Power (Yellow)
+12 V
Monitor
Analog
Frame Grabber
GND (Gray)
}
Jack