Filter
Top Products
EN
32
USING MENUS FOR DETAILED ADJUSTMENT
For Recording Menu
This camcorder is equipped with an easy-to-use,
on-screen menu system that simplifies many of the
more detailed camcorder settings (੬ pg. 32 – 35).
1 Set the Power Switch @ to “ ” while pressing
down the Lock Button $ located on the switch. Open
the LCD monitor fully or pull out the viewfinder fully.
2 Press MENU 4. The Menu Screen appears.
3 Press + or – 5 to select the desired function menu,
and press SELECT/SET 3.
4 Function menu setting depends on the function.
If you have selected “ WIPE/FADER”,
“ PROGRAM AE”, “ EXPOSURE” or
“ W. BALANCE” . . .
..... see the column on the right.
If you have selected “ CAMERA”, “ MANUAL”,
“ SYSTEM”, “ CAMERA DISPLAY” or
“ DSC” . . .
..... go to step 5.
5 Press + or – 5 to select the desired function and
press SELECT/SET 3. The Sub Menu appears. Then,
press + or – 5 to select the parameter, and press
SELECT/SET 3. Selection is complete.
6 Press + or – 5 to select “ RETURN” and press
SELECT/SET 3 twice. The Menu Screen closes.
•The icon represents “END”.
NOTE:
When the Menu Screen is left on for a couple of minutes, a
residual image may be left on the screen and it may take
several seconds for the residual image to disappear. This is
not due to any defect of the unit.
WIPE/FADER
Refer to “Fade/Wipe Effects” (੬ pg. 28).
PROGRAM AE
Refer to “Programme AE With Special Effects”
(੬ pg. 27).
EXPOSURE
Refer to “Exposure Control” and “Iris Lock” (੬ pg. 30,
31).
W.BALANCE
Refer to “White Balance Adjustment” and “Manual
White Balance Operation” (੬ pg. 31).
CAMERA
Settings made in the “ CAMERA” Menu remain
effective whether the Power Switch @ is set to “ ” or
“ ”. However, the menu settings can be changed only
when the Power Switch @ is set to “ ”.
REC MODE
Allows you to set the tape recording mode ([SP] or
LP) depending on your preference (੬ pg. 10).
SOUND MODE
[12bit]: Enables tape recording of stereo sound on
four separate channels, and is recommended for use
when performing audio dubbing. (Equivalent to the
32 kHz mode of previous models)
16bit: Enables tape recording of stereo sound on two
separate channels. (Equivalent to the 48 kHz mode of
previous models)
ZOOM
10X*/16X**: When set to “10X*/16X**” while using
digital zoom, the zoom magnification will reset to
10X*/16X** since digital zoom will be disengaged.
[40X]: Allows you to use the Digital Zoom. By digitally
processing and magnifying images, zooming is
possible from 10X*/16X** (the optical zoom limit), to a
maximum of 40X digital magnification.
500X*/700X**: Allows you to use the Digital Zoom. By
digitally processing and magnifying images, zooming
is possible from 10X*/16X** (the optical zoom limit),
to a maximum of 500X*/700X** digital magnification.
* GR-DX300 only.
** GR-DX95/DX75 only.
[ ] = Factory-preset
EC MODER
–
RETURN
AGC
AIN UPG
–
FULL
NAP MODES
–
40
X
OOMZ
–
12
bit
OUND MODES
–
MANUALAVIGAT IONN–
MACER
A