Filter
Top Products
EN29
RETAKE (R/F) Button
FEATURE:
Quick Review
PURPOSE:
To check the end of the last recording.
OPERATION:
1)Press “ ” and release quickly during the Record–
Standby mode.
Ⅲ Tape is rewound for about 2 seconds and played
back automatically, then pauses in Record–Standby
mode for the next shot.
NOTE:
Distortion may occur at the start of playback. This is
normal.
FEATURE:
Retake
PURPOSE:
To re-record certain segments.
OPERATION:
1)Make sure the camcorder is in the Record–Standby
mode.
2)Press either RETAKE to reach the start point for new
recording. Pressing “F” forwards the tape and
pressing “R” reverses it.
3)Press the Recording Start/Stop Button to start
recording.
NOTE:
Noise bars appear and pictures may become
monochrome or darken during Retake. This is normal.
FEATURE:
Picture Stabilizer
PURPOSE:
To compensate for unstable images caused by camera-
shake, particularly at high magnification.
OPERATION:
1)Press P. STABILIZER. “ ”appears.
Ⅲ To switch off the Picture Stabilizer, press
P. STABILIZER. The indicator disappears.
NOTES:
●
Accurate stabilization may not be possible if hand
shake is excessive, or under the following conditions:
•
When shooting subjects with vertical or horizontal
stripes.
•
When shooting dark or dim subjects.
•
When shooting subjects with excessive backlighting.
•
When shooting scenes with movement in various
directions.
•
When shooting scenes with low-contrast backgrounds.
●
Switch off the Picture Stabilizer when recording
with the camcorder on a tripod.
●
The “ ” indicator appears blinking if the
Stabilizer cannot be used.
Display
P. STABILIZER Button
Picture stabilizer
indicator