Filter
Top Products
68 EN
SYMPTOM POSSIBLE CAUSE(S)
SHOOTING
Although the SNAPSHOT Button is
pressed, a still image is not stored in
the built-in memory.
Self-Timer Shooting is not available.
It is not possible to shoot in
sucession.
Although “ALL” is selected in the
DELETE Menu Screen, all still images
cannot be deleted.
Date/Time Insert is not performed
while shooting a still image.
Instant Titles are not displayed while
shooting a still image.
Some settings cannot be changed in
the Menu Screen.
● When the number of remaining shots available reaches “0”
(blinking), it becomes impossible to take your next shot.
Perform “DELETE” function to remove some still images
already stored in memory (੬ pg. 58).
● Pressing the Recording Start/Stop Button does not start
recording in the Self-Timer Shooting procedure. Press the
SNAPSHOT Button (੬ pg. 44).
● A still image is in the process of being stored in memory for
approx. 2 seconds after the SNAPSHOT Button is pressed.
During that time, it is impossible to take another shot. When
the still image disappears and the scene you are currently
aimed at appears on the screen, take another shot (੬ pg. 22).
● The “Protect” function is in effect for some still images. If
they are not necessary, cancel the “Protect” function, then
try deleting all still images again (
੬ pg. 57).
● It is not possible to display the date/time on a still image.
● It is not possible to display the Instant Titles on a still image.
● It is not possible to set “REC TIME” in the Menu Screen.
PLAYBACK
OTHER
When the System Select Switch is set to “D.S.C.”:
Since the camcorder is a microcomputer-controlled device, external noise and interference (from a TV, a
radio, etc.) might prevent it from functioning properly. For example, when a still image you shot is stored
in the camcorder's built-in memory, the above may cause the following: Although the remaining number
of shots indicator shows that shooting is possible, a still image cannot be stored in memory after shooting.
In such a case, initialize the memory by following steps 1 through 3 below. Please note that initialization
deletes all the still images (including ones for which you performed the “Protect” function) stored in the
camcorder’s memory. If you wish to keep any of the still images that are stored in memory, before
initialization first transfer them to a PC and save them. If image data is corrupt, transfer is impossible.
1. Set the System Select Switch to “D.S.C.”, then set the Power Switch to
“PLAY”.
2. Press the SP/EP Recording Mode Button for more than 2 seconds. The
FORMAT Menu Screen appears.
3. Rotate the Select Dial to move the highlight bar to “CANCEL” or
“ENTER”, then press it.
•“CANCEL” does not initialize the memory.
•“ENTER” initializes the memory. During initialization, “ENTER” blinks.
When initialization is complete, the screen becomes blue back.
CAUTION:
While “ENTER” is selected and it is blinking, switching off the camcorder or removing the power supply
unit (battery pack or AC Power Adapter/Charger) may cause the camcorder’s built-in memory to become
corrupt. Never remove the power supply unit at this stage.
FORMAT Menu
FORMAT
CANCEL
ENTER
TROUBLESHOOTING
(cont.)