Filter
Top Products
38 EN
RECORDING
Advanced Features (cont.)
DATE/TIME
TAPE LENGTH*
Menu Screen Available Using The MENU Button (cont.)
: Factory-preset
TELE MACRO
PICTURE**
SNAPSHOT
* Activated only with the System Select Switch set to “VIDEO”. If the System Select Switch is set to “D.S.C.”,
this function will not be activated although the highlight bar will move on the Menu Screen like the setting
procedure.
**Activated only with the System Select Switch set to “D.S.C.”. If the System Select Switch is set to “VIDEO”,
this function will not be activated although the highlight bar will move on the Menu Screen like the setting
procedure.
Functions listed without an asterisk are available with the System Select Switch set to either “D.S.C.” or
“VIDEO”.
OFF
ON
FULL
PIN-UP
MULTI-4
MULTI-9
M.DRIVE
OFF
ON
OFF
ON
Usually the distance to a subject where the lens is in focus
depends on the zoom magnification. Unless there is a distance of
more than 1m (3.3 ft.) to the subject, the lens is out of focus at the
maximum telephoto setting. When set to “ON”, you can shoot a
subject as large as possible at a distance of approx. 60 cm (2 ft.).
•Depending on the zoom position, the lens may go out of focus.
Allows you to set the current date and time (੬ pg. 13).
Allows you to set the tape length depending on the tape used (੬ pg. 14).
Allows you to select the image setting “FINE” or “STD” when storing in the
camcorder's memory (੬ pg. 24).
Displayed with the System Select Switch set to either “VIDEO”
(੬ pg. 26) or “D.S.C.” (੬ pg. 23).
Displayed only with the System Select Switch set to “D.S.C.”
(੬ pg. 23).
This feature allows you to set the parameters for Animation and Time-Lapse
recording (੬ pg. 45).
This feature allows you to set the parameters for Self-Timer (੬ pg. 44) and Time-
Lapse recording (੬ pg. 45).
The tally lamp remains off at all times.
The tally lamp comes on to signal the start of recording.
Allows you to select the language (ENGLISH, FRENCH, SPANISH or PORTUGUESE)
of Instant Titles (੬ pg. 35).
This number is necessary when connecting the camcorder to a device such as a computer
using the J terminal (JLIP). The numbers range from 01 to 99. Factory setting is 06.
Automatic demonstration will not take place.
Demonstrates certain functions such as Fade/Wipe, etc. When
“DEMO MODE” is set to “ON” and the Menu Screen is closed,
the demonstration starts.
NOTES:
●
When a tape whose Erase Protection tab is in the position that
allows recording is loaded in the camcorder, demonstration is
not available.
●
By turning off the camcorder or inserting a tape whose Erase
Protection tab is in the position that allows recording into it,
“DEMO MODE” is set to “OFF” automatically.
●
During the demonstration, all functions except zoom are
disabled.
REC TIME*
JLIP ID NO.
DEMO MODE*
INT. TIME
TALLY LAMP*
TITLE LANG.*