Filter
Top Products
42
EN
Snapshot (For Tape Recording)
This feature lets you record still images that look like
photographs onto a tape.
SNAPSHOT MODE SELECTION
1 Set the VIDEO/MEMORY Switch to “VIDEO”
(GR-DVL767/DVL367/DVL365 only), then set the
Power Switch to “
M
ANUA
L
” while pressing down the
Lock Button located on the switch.
2 Press the MENU/BRIGHT wheel in. The Menu
Screen appears.
3
Rotate the MENU/BRIGHT wheel to select “
CAMERA”. Press it and the CAMERA Menu appears.
4 Rotate the MENU/BRIGHT wheel to select
“SNAP MODE”, then press it.
5 Rotate the MENU/BRIGHT wheel to select the
desired Snapshot mode, then press it.
Rotate the MENU/BRIGHT wheel to select
“ RETURN” and press it twice. The Menu Screen
closes.
SNAPSHOT RECORDING
1 Press SNAPSHOT. “PHOTO” appears while the
snapshot is being taken.
If you press during Record-Standby . . .
..... “PHOTO” appears and a still image will be recorded
for approx. 6 seconds, then the camcorder re-enters
the Record-Standby mode.
If you press during Recording . . .
..... “PHOTO” appears and a still image will be recorded
for approx. 6 seconds, then the normal recording
resumes.
• Regardless of the Power Switch position (“
AUTO
” or
“
MANUAL
”), Snapshot recording takes place using the
selected Snapshot mode.
Motor Drive Mode
Keeping SNAPSHOT pressed provides an effect similar
to serial photography. (Interval between still images:
approx. 1 second)
NOTES:
● To remove the shutter sound, ੬ “BEEP” on pg. 46, 48.
● If Snapshot recording is not possible, “PHOTO” blinks
when SNAPSHOT is pressed.
● If Programme AE with special effects (੬ pg. 38) is
engaged, certain modes of Programme AE with special
effects are disabled during Snapshot recording. In such
a case, the icon blinks.
● If SNAPSHOT is pressed when “DIS” is set to “ON”
(
੬ pg. 47), the Stabiliser will be disabled.
● The Motor Drive mode is disabled when “REC
SELECT” is set to “
/ ” in the Menu Screen
(
੬ pg. 49).
● If “REC SELECT” is set to “
/ ” in the DSC
Menu Screen, still images are recorded on the memory
card as well (640 X 480 pixels).
● During tape playback as well, all snapshot modes are
available when “
COPY” is set to “OFF” in the
Menu Screen (
੬ pg. 50). However, the shutter sound
is not heard.
● During Snapshot recording, the image displayed in the
viewfinder may be partially missing. However, there is
no effect in the recorded image.
● When a cable is connected to the AV connector, the
shutter sound is not heard from the speaker, however it
is recorded onto the tape.
FOR RECORDING
(cont.)
SNAP MODE –
PIN–UP
FRAME
FULL
SNAPSHOT Button
Lock Button
VIDEO/MEMORY Switch
(GR-DVL767/DVL367/
DVL365 only; open the
LCD monitor to access
this switch.)
Display
Menu Screen
There is the sound effect of a shutter closing.
FULL
Snapshot mode
with no frame
FRAME
Snapshot mode
with frame
PIN-UP
Pin-Up mode
Power Switch
GR-DVL767/DVL367/
DVL365 only