66 EN
Audio Dub
Standby mode
6e
PAUSE
PLAY
A.DUB
STOP
MIC
USING THE REMOTE CONTROL UNIT
(cont.)
Audio Dubbing
The audio track can be customized only when recorded
in the 12-bit mode (੬ pg. 39).
NOTES:
●
Audio Dubbing is not possible on a tape recorded in
16-bit audio, on a tape recorded in the LP mode or on
a blank portion of a tape.
●
To perform Audio Dubbing while watching on the
television, make connections (
੬
pg. 22).
1
Play back the tape to locate the point where editing
will start, then press PAUSE (6).
2
While holding A.DUB (e) on the remote control,
press PAUSE (6). “6e” appears.
3
Press PLAY (
4
), then begin “narrating”.
Speak into the microphone.
•To pause dubbing, press PAUSE (6).
4
To end Audio Dubbing, press PAUSE (6), then STOP
(5).
To hear the dubbed sound during playback . . .
.... set “12BIT MODE” to “SOUND 2” or “MIX” in the
Menu Screen (੬ pg. 42, 44).
NOTES:
●
Sound is not heard from the speaker during Audio
Dubbing. To hear sound, connect optional headphones
to the AV IN/OUT (headphone) connector (GR-DVX78
only).
●
When editing onto a tape that was recorded at 12-bit,
the old and new soundtracks are recorded separately.
●
If you dub onto a blank space on the tape, the sound
may be disrupted. Make sure you only edit recorded
areas.
●
If feedback or howling occurs during TV playback,
move the camcorder’s microphone away from the TV,
or turn down the TV’s volume.
●
If you change from 12-bit to 16-bit in mid-recording
and then use the tape for Audio Dubbing, it is not
effective from the point where 16-bit recording began.
●
During Audio Dubbing, when the tape moves to scenes
recorded in the LP mode, scenes recorded in 16-bit
audio or a blank portion, Audio Dubbing stops
(
੬
pg. 91).
●
To perform Audio Dubbing with a video unit con-
nected to the camcorder’s AV connector, first set
“S/AV INPUT” to “ON” in the Menu Screen
(GR-DVX78 only
੬
pg. 42).
Speaker
Display
AV IN/OUT
(headphone) connector
(GR-DVX78 only)
Stereo microphone
Remote
sensor
Located
beneath
the cover.
GR-DVX78 only