Filter
Top Products
8 EN
SP
LP
T30
T30
T45 T60
SP
GETTING STARTED
(cont.)
Tape Length Setting
Set the tape length according to the length of the tape used.
SET TAPE LENGTH
1
Press T30•45•60 until the required indication appears
in the LCD monitor or the veiwfinder. T30 = 30 minutes
of recording time, T45 = 45 minutes, and T60 = 60
minutes. (in SP)
NOTE:
The tape remaining time (
੬
pg. 11) displayed in the LCD
monitor or the viewfinder is correct only if the correct tape length
has been selected.
Recording Mode Setting
Set depending on your preference.
SET RECORDING MODE
1
Press SP•LP button. “SP” (Standard Play) provides
higher picture and sound quality and is better for
dubbing, while “LP” (Long Play) is more economical,
recording at 1/2 the speed of SP.
NOTE:
If the recording mode is switched during recording, the playback
picture will be blurred at the switching point.
Loading/Unloading A Cassette
OPEN LCD MONITOR
1
Slide MONITOR OPEN and open the LCD monitor to
an angle of over 45 degrees.
OPEN CASSETTE HOLDER
2
Press EJECT until the holder opens. Do not use force to
open.
INSERT/REMOVE CASSETTE
3
Make sure the label is facing outward.
CLOSE CASSETTE HOLDER
4
Press PUSH and make sure the holder is closed and
locked.
CLOSE LCD MONITOR
5
First make sure the holder is closed. Then close the LCD
monitor.
NOTES:
●
Closing the LCD monitor while the cassette holder is still open
may cause damage to the LCD monitor.
●
A cassette holder can’t be opened unless a power supply is
attached.
●
Make sure that the tape is not slack when loading the cassette.
If there is any slack, turn the gear on the cassette in the
direction of the arrow to take up the slack.
●
Make sure the Erase Protection tab is in the position that allows
recording. If not, slide the tab. Some cassettes have removable
tabs. If the tab has been removed, cover the hole with adhesive
tape.
●
The cassette holder can’t be opened while the camcorder is in
the record mode.
T30•45•60 tape length select button
Recording mode
indicator
Tape length indicator
1
1
2
2
3
3
4
4
5
Gear
Turn to take
up slack.
Erase Protection
SP-LP recording
mode button
Set POWER to “CAMERA”.
LCD monitor
or viewfinder