Filter
Top Products
GETTING STARTED
GETTING STARTED
EN 13
MasterPage: Start_Right
1 Adjust the velcro strip.
2 Pass your right hand through
the loop and grasp the grip.
3 Adjust your thumb and
fingers through the grip to
easily operate the Recording
Start/Stop Button, Power
Switch and Power Zoom Lever.
Be sure to fasten the velcro
strip to your preference.
1 Set the Power Switch to “A” or “M” while pressing
down the Lock Button located on the switch.
2 Make sure the LCD monitor is closed and locked. Pull
out the viewfinder fully and adjust it manually for best
viewability.
3 Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
CAUTION:
When retracting the viewfinder, take care not to pinch your
fingers.
1 Set the Power Switch to “M”
or “PLAY” while pressing down
the Lock Button located on the
switch.
2 Open the LCD monitor fully.
(੬ pg. 15)
● To adjust the brightness of the
viewfinder, pull out the
viewfinder fully and set
“PRIORITY” to “FINDER”
(੬ pg. 27, 29).
3 Press or until the
brightness control indicator on
the display moves and the
appropriate brightness is
reached.
To attach the camcorder to a tripod, align the direction
stud and screw to the mounting socket and stud hole on
the camcorder. Then tighten the screw clockwise.
●Some tripods are not
equipped with studs.
Grip Adjustment
Viewfinder Adjustment
PAUSE
Dioptre Adjustment Control
Brightness Adjustment Of The Display
Tripod Mounting
BRIGHT
MENU
(Up)
(Down)
SET
GR-D231PAL.book Page 13 Thursday, January 22, 2004 2:57 PM