Filter
Top Products
44 EN
USING THE REMOTE CONTROL UNIT
(cont.)
1
2
3
4
5
6
7
8
––: –– ~
~
~
~
~
~
~
~
–
–
:
––
0
:
000
––
TOTAL
CODETIME
NIOUT
MODE
PLAY
REW
FF
ON/OFF
IN/OUT
CANCEL
SELECT SCENES
4
Point the remote control at the camcorder’s remote
sensor. Press PLAY (
4
) and then press ON/OFF on
the remote control. The Random Assemble Editing
Menu appears.
5
At the beginning of the scene, press IN/OUT on the
remote control. The Edit-In position appears in the
Random Assemble Editing Menu.
6
At the end of the scene, press IN/OUT. The Edit-Out
position appears in the Random Assemble Editing
Menu.
7
Repeat steps 5 and 6 to register additional scenes.
•To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
NOTES:
●
When choosing a scene, set Edit-In and Edit-Out points
so that there is a relatively large difference between
them.
●
If the search time for an in-point exceeds 5 minutes, the
recording deck’s Record-Standby mode will be canceled
and editing will not take place.
●
If there are blank portions before or after the Edit-In and
Edit-Out points, a blue screen may be included in the
edited version.
●
Since time codes register time only as accurately as
seconds, the time code total time may not match the
total program time exactly.
●
Turning off the camcorder’s power erases all registered
Edit-In and Edit-Out points.
Random Assemble
Editing Menu
Program
Remote sensor
RM-V700U
(optional)