Filter
Top Products
48 EN
SYSTEM CONNECTIONS
NOTES:
●
In order to maintain optimum performance of the
camcorder, provided cables may be equipped with
one or more core filter. If a cable has only one core
filter, the end that is closest to the filter should be
connected to the camcorder.
●
It is recommended to use the AC Adapter as the
power supply instead of the battery pack
(
੬
pg. 8).
●
Never connect the PC connection cable and the
DV cable simultaneously to the camcorder.
Connect only the cable you wish to use to the
camcorder.
●
The date/time information cannot be captured into
the PC.
●
Refer to the instruction manuals of the PC and
Software.
●
The still images can also be transferred to a PC
with a DV connector-equipped capture board.
●
When using a DV cable, be sure to use the
optional JVC VC-VDV206U or VC-VDV204U DV
cable depending on the type of DV connector (4
or 6 pins) on the PC, or use the DV cable provided
with the capture board.
●
The system may not work properly depending on
the PC or capture board you are using.
To DV
IN/OUT
DV cable
(optional)
To DV
connector
Power Switch
PC with DV
connector
PC
Core filter
OR
Core filter
To RS-232C
PC connection
cable (optional)
To PC
(DIGITAL
PHOTO)
Connection To A Personal Computer
[A] Using PC connection cable
This camcorder can transfer still images to a PC by
using the optional software HS-V16U.
[B] Using DV cable
It is also possible to transfer still images to a PC with
a DV connector by using software equipped with the
PC or commercially available software.
1
Make sure the camcorder and PC are turned off.
2
Connect the camcorder to your PC using the
appropriate cable as shown in the illustration.
3
Turn the camcorder’s Power Switch to “ ”
while pressing down the Lock Button located on
the switch and turn on the PC.
•Refer to the instruction manual of the software
on how to transfer a still image to the PC.
4
When finished, turn off the PC first, then the
camcorder.
[A]Using PC connection cable
[B]Using DV cable