Filter
Top Products
EN5
AUTOMATIC DEMONSTRATION
Automatic Demonstration takes place when “DEMO MODE”
is set to “ON” (factory-preset).
Ⅲ Available when the Power Switch is set to “
” or “ ” and
no cassette is in the camcorder.
Ⅲ Performing any operation during the demonstration stops
the demonstration temporarily. If no operation is performed
for more than 1 minute after that, the demonstration will
resume.
Ⅲ “DEMO MODE” remains “ON” even if the camcorder
power is turned off.
Ⅲ To cancel Automatic Demonstration:
1. Set the Power Switch to “
” while pressing down the
Lock Button located on the switch and press the MENU/
BRIGHT wheel in. The Menu Screen appears.
2. Rotate the MENU/BRIGHT wheel to select “
SYSTEM”
and press it. The SYSTEM Menu appears.
3. Rotate the MENU/BRIGHT wheel to select “DEMO
MODE” and press it. The Sub Menu appears.
4. Rotate the MENU/BRIGHT wheel to select “OFF” and
press it.
5. Rotate the MENU/BRIGHT wheel to select “
1
RETURN”,
and press it twice.
The normal screen appears.
NOTE:
If you do not detach the Lens Cap, you cannot see the actual changes of the Automatic Demonstration
activated on the LCD monitor or viewfinder.
MODEDEMO –
ON
OFF
MENU/BRIGHT Wheel
Sub Menu
132
How To Attach The Lens Cap
To protect the lens, attach the provided lens cap to the camcorder as shown in the illustration.
NOTE:
To confirm the lens cap is on correctly make sure the cap is flush to the camera.
Lock Button
Power Switch