Filter
Top Products
EN37
FOCUS
FOCUS
A M
P
L
A
Y
O
F
F
C
A
M
E
R
A
5
S
FOCUS
EXPOSURE AUTO
OFF
OFF
AUTO
MANUAL
W. BALANCE
FADER
/ WIPE
P. AE
/ EFFECT
4
END
0FLASH ADJ.
TO MODE MENU
MANUAL FOCUS
NOTE:
You should already have made the necessary viewfinder
adjustments (
੬
pg. 11). If you have not, do so before
continuing.
1
SELECT OPERATION MODE
Set the Operation Switch to “ ”. Then, set the
Power Switch to “ ” or “5S” while pressing
down the Lock Button. Pull out the viewfinder fully or
open the LCD monitor fully.
2
ACCESS RECORDING MENU
Press MENU/SET. The Recording Menu appears.
3
ACCESS “FOCUS”
Rotate MENU/SET to move the highlight bar to
“FOCUS”, then press it.
4
ACCESS MANUAL FOCUS
Rotate MENU/SET to display “MANUAL”, then press
it. The Recording Menu disappears and “FOCUS” is
displayed in the upper left corner. The focus is locked
at this point.
5
ADJUST FOCUS
To farther subject . . .
.... rotate MENU/SET upward. “ ” appears and
blinks. Go to step 6.
To nearer subject . . .
.... rotate MENU/SET downward. “ ” appears and
blinks. Go to step 6.
6
END ADJUSTMENT OF FOCUS
Press MENU/SET. Focus adjustment is complete. The
indication changes from “FOCUS” to “MANUAL”.
•If you want to reset the focus, repeat from step 2.
To Change To Auto Focus . . .
.... rotate MENU/SET to display “AUTO” then press it in
step 4. The manual focus indicators disappear. Or, set
the Operation Switch to “ ”.
NOTES:
●
After the Power Switch is set to “OFF”, Manual Focus is
reset to “AUTO”.
●
Be sure to focus the lens in the maximum telephoto
position when you use the Manual Focus mode. If you
focus in on a certain subject in the wide-angle position,
sharply focused images cannot be obtained when
zoomed up because the depth-of-field is reduced at
longer focal lengths.
●
When the focus level cannot be adjusted any farther or
closer, “ ” or “ ” will blink.
MENU/SET Dial Power Switch
Recording Menu
Display
Lock Button
Power lamp
Operation Switch