Filter
Top Products
EN 49
EDITING
MasterPage: Start_Right
ADVANCED FEATURES
● Never connect the USB cable and the DV
cable simultaneously to the camcorder.
Connect only the cable you wish to use to the
camcorder.
● When using a DV cable, be sure to use the
optional JVC VC-VDV206U or VC-VDV204U DV
cable depending on the type of DV connector
(4 or 6 pins) on the PC.
● If the PC connected to the camcorder via the USB
cable is not powered, the camcorder does not
enter the USB mode.
● The date/time information cannot be captured into
the PC.
● Refer to the instruction manuals of the PC and
Software.
● The still images can also be transferred to a PC
with a DV connector-equipped capture board.
● The system may not work properly depending on
the PC or capture board you are using.
You can record a new scene into a previously
recorded tape, replacing a section of the original
recording with minimal picture distortion at the in
and outpoints. The original audio remains
unchanged.
● Use the provided remote control.
NOTES:
● Before performing the following steps, make sure
that “TIME CODE” is set to “ON” in CAMERA
DISPLAY and VIDEO DISPLAY menus.
(੬ pg. 33, 36, 38)
● Insert editing is not possible on a tape recorded in
the LP mode or on a blank portion of a tape.
1 Play back the
tape, locate the Edit-
Out point and press
PAUSE (9).
Memorize the time
code at this point
(੬ pg. 19) since it
will be needed to stop editing in step 5.
2 Press REW (
3
) until the Edit-In point is
located, then press PAUSE (9).
3 Press and hold INSERT (I) on the remote
control, then press PAUSE (9). The “9I”
indicator and the Time Code (min.:sec.) appear
and the camcorder enters Insert-Pause mode.
4 Press START/STOP to begin editing.
● To pause editing, press START/STOP. Press it
again to resume editing.
5 When the time code reaches Edit-Out point
(time code from step 1), press START/STOP,
then STOP (8) to end Insert Editing.
NOTES:
● Program AE and special effects (੬ pg. 44, 45)
can be used to spice up the scenes being edited
during insert editing.
● During insert editing, the date and time
information changes.
● If you perform insert editing onto a blank space on
the tape, the audio and video may be disrupted.
Make sure you only edit recorded areas.
● During insert editing, when the tape moves to
scenes recorded in the LP mode or a blank
portion, insert editing stops. (੬ pg. 55)
Insert Editing
PAUSE
STOP
REW
INSERT
START/
STOP
GR-X5US.book Page 49 Tuesday, May 31, 2005 11:31 AM