Filter
Top Products
GETTING STARTED
EN 19
GETTING STARTED
MasterPage: Start_Right
The brightness of the display can be adjusted.
1 Set the power switch to or while
pressing down the lock button located on the
switch.
2 Open the LCD monitor fully. (੬ pg. 9)
3 Press MENU. The menu screen appears.
4 Press / to select [DISPLAY], then press
49.
5 Press / to select
[BRIGHT], and press 49.
The brightness control
indicator appears.
6 Press / until the appropriate brightness
is reached.
7 Press 49 to clear the brightness control
indicator from the display.
1 Adjust the velcro strip.
2 Pass your right hand
through the loop and grasp
the grip.
3 Adjust your thumb and
fingers through the grip to
easily operate the
recording start/stop button,
power switch and zoom
lever. Be sure to fasten the
velcro strip to your
preference.
To attach the camera to a
tripod, align the direction
stud and screw to the
mounting socket and
stud hole on the camera.
Then tighten the screw
clockwise.
● Some tripods are not
equipped with studs.
Brightness Adjustment of the
Display
Grip Adjustment
Tripod Mounting
M5E3PAL.book Page 19 Tuesday, June 14, 2005 1:40 PM