JVC GR-DVL725 Camcorder User Manual


 
62
EN
USING THE REMOTE CONTROL UNIT
(cont.)
For More Accurate Editing
Some VCRs make the transition from Record-Pause
to Record mode faster than others. Even if you begin
editing for the camcorder and the VCR at exactly the
same time, you may lose scenes you wanted, or find
that you have recorded scenes you did not want. For
a cleanly edited tape, confirm and adjust the timing of
the camcorder against your VCR.
DIAGNOSING VCR/CAMCORDER TIMING
1 Play back the tape in the camcorder, then point
the remote control at the camcorder’s remote sensor
and press R.A.EDIT ON/OFF or ON/OFF.
The Random Assemble Editing Menu appears.
2 Perform Random Assemble Editing on Program 1
only. In order to check VCR and camcorder timing,
select the beginning of a scene transition as your
Edit-In point.
3 Play back the dubbed scene.
• If any images from the scene prior to the transition
you chose for your Edit-In point were recorded, that
means your VCR moves too quickly from Record-
Pause to Record mode.
• If the scene you tried to dub starts in progress, the
VCR is slow to start recording.
ADJUSTMENT OF VCR/CAMCORDER TIMING
4 Point the remote control at the camcorder’s
remote sensor and press R.A.EDIT ON/OFF or ON/
OFF to make the Random Assemble Editing menu
disappear, then press the MENU/BRIGHT wheel in.
The Menu Screen appears.
5 Rotate the MENU/BRIGHT wheel to select “
VIDEO” and press it. The VIDEO Menu appears.
Then, rotate it to “SYNCHRO” and press it. The value
for “SYNCHRO” is highlighted.
6 Based on the diagnostics performed, you can
now advance the VCR’s record timing by rotating the
MENU/BRIGHT wheel towards “+”. You can also
delay the VCR’s record timing by rotating the MENU/
BRIGHT wheel towards “”. The adjustment range is
from –1.3 to +1.3 seconds, in 0.1-second increments.
Press the MENU/BRIGHT wheel in to finish the
setting.
7 Rotate the MENU/BRIGHT wheel to select
RETURN” and press it twice.
Now perform Random Assemble Editing beginning
with step 4 on page 60.
NOTES:
Before performing actual Random Assemble Editing, do
a few Random Assemble Editing trial runs to check
whether the value you have input is appropriate or not,
and make adjustments accordingly.
Depending on the recorder, there may be situations
where the timing difference cannot be fully corrected.
1
2
3
4
5
6
7
8
––: –– ~
~
~
~
~
~
~
~
––
NIOUT
MODE
ROSYNCH
O.1
:
––
0
:
000
TOTAL
CODETIME
ON/OFF
R.A.EDIT
ON/OFF
Random Assemble
Editing Menu
Program 1
Remote sensor
RM-V717U
(Provided with
GR-DVL820 only)
RM-V700U
(optional)
OR
VIDEO Menu