JVC LYT1193-001A Camcorder User Manual


 
6 EN
Master Page: Left
How To Attach The Core Filter
Attach the core filters to the cables. The core filter
reduces interference.
Types of core filters
* Optional
(If you have an optional JVC i.LINK cable
VC-VDV206U or VC-VDV204U with core
filters, it is not necessary to attach the provided
core filter. If you are going to use any other
i.LINK cable, attach the provided core filter.)
** Attach two core filters to both ends of the cable.
The procedure below is an example of winding
cable once.
1 Release the stoppers on both ends of the core
filter.
2 Run the cable through the core filter, leaving
approx. 3 cm of cable between the cable plug
and the core filter. Wind the cable once around
the outside of the core filter as shown in the
illustration.
Wind the cable so that it is not slack.
3 Close the core filter until it clicks shut.
NOTES:
Take care not to damage the cable.
When connecting a cable, attach the end with the
core filter to the camcorder.
How To Attach The Strap
1 Following the illustration, thread the strap
through the eyelet a.
2 Fold it back and thread it through the buckle b.
3 Repeat the procedure to attach the other end of
the strap to the other eyelet c.
4 Confirm the strap is not twisted.
Size Cable
Times to
wind
Large i.LINK cable* Twice
Medium USB cable** Once
Small
DC cord
Audio cable
Once
Stopper
3 cm
Wind once.
GR-PD1PAL.book Page 6 Tuesday, June 17, 2003 7:31 PM