Filter
Top Products
Installation
Step 2: Pass all the signal cables through the hole for the cables.
Optionally connect a video monitor to the BNC connector if you want to perform focus/zoom adjustments
during the installation.
Step 3: For static electricity protection, ensure that the rubber pad is placed inside
the mounting bracket base.
Step 4: Modify the position of camera
Loosen the two screws (left and right) first (just rotate slightly one circle or the screws will fall down),
second, rotate the Retaining ring then you will be able to hold the camera and adjust its angle. Fasten
the screws and retaining ring to ensure the desired angle.
8