Filter
Top Products
3
Preparations
DVR-6300 (EN/K,P,E,X)
Unpacking
Unpack the unit carefully and make sure that all the accessories are present.
If any accessories are missing, or if the unit is damaged or fails to operate, notify your dealer immediately. If the unit
was shipped to you directly, notify your shipper immediately. Kenwood recommends that you retain the original
carton and packing materials in case you need to move or ship the unit in the future.
Keep this manual handy for future reference.
Accessories
Please confirm that the following accessories are present.
Video cord (Yellow)(1)
Introduction
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the
modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change
or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful inter-
ference to radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following mea-
sures:
– – Reorient or relocate the receiving antenna.
– – Increase the separation between the equipment and receiver.
– – Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– – Consult the dealer or an experienced radio / TV technician for help.
CAUTION:
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous radia-
tion exposure.
In compliance with Federal Regulations, the following are repro-
ductions of labels on, or inside the product relating to laser prod-
uct safety.
KENWOOD CORPORATION
2967-3, ISHIKAWA-CHO,
HACHIOJI-SHI,
TOKYO, JAPAN
KENWOOD CORP. CERTIFIES THIS EQUIPMENT
CONFORMS TO DHHS REGULATIONS NO. 21 CFR
1040.10, CHAPTER 1, SUBCHAPTER J.
Location: Back Panel
For the U.S.A.
For the U.S.A.
For Canada
NOTICE: This Class B digital apparatus complies with
Canadian ICES-003.
FM indoor antenna (1)
Loop antenna (1)
Remote control unit (1) Batteries
(R03/AAA) (2)
Speaker cords (6)
(For Europe) (For U.S.A., Canada and
Australia)
Note to CATV system installer
This reminder is provided to call the CATV system installer's at-
tention to Article 820-40 of the NEC that provides guidelines for
proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the build-
ing, as close to the point of cable entry as practical.
For the U.S.A.
Accessories for speaker part
(For DVT-6300 and DVT-7300)
Length
For Front (2) 4.5 m (177-3/16")
For Center (1) 3 m (118-1/8")
For Rear (2) 8 m (314-15/16")
For Subwoofer (1) 4.5 m (177-3/16")
Cushion (15)
(Small : 11 pcs ✕ 1 sheet) (Big : 4 pcs ✕ 1 sheet)
*5476/01-08/EN 04.7.27, 2:05 PM3