Filter
Top Products
43
DVR-6300 (EN/K,P,E,X)
Knowledge
In case of difficulty
Operation to reset
What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the
table below to see if the problem can be corrected before seeking help from your dealer or service representative.
The microprocessor may fall into malfunction (impossibility to operate erroneous display, etc.) when the power
cord is unplugged while power is ON or due to an external factor.
In this case, switch off the power, wait for several seconds, and then switch the power on again.
÷ Connect properly referring to “System con-
nections”.
÷ Switch MUTE OFF.
÷ Unplug the headphone plug.
÷ Connect properly referring to “System con-
nections”.
÷ Connect antennas.
÷ Select a band.
÷ Tune to the frequency of the desired sta-
tion.
÷ Install the outdoor antenna in an apart posi-
tion from the road.
÷ Switch the suspected electric appliance OFF.
÷ Install the TV or the system at an increased
distance between them.
÷ Preset stations with tunable frequencies.
÷ Preset stations again.
÷ Select Surround with the LISTEN MODE
key.
÷ The speaker cords are disconnected.
÷ The MUTE key of remote control unit is switched
ON.
÷ The headphone plug is inserted into the jack.
÷ The speaker cords are disconnected.
÷ The antennas have not been connected.
÷ A proper broadcasting band has not been se-
lected.
÷ The frequency of the station to be received is
not tuned.
÷ Car ignition noise.
÷ Influence of an electric appliance.
÷ A TV set is installed near the system.
÷ The frequency of the preset station is not
tunable.
÷ The preset memory has been cleared because
the power cord has been unplugged for a long
period.
÷ The LISTEN mode is STEREO.
Sound is not produced.
Sound is not produced from the left
or right speakers.
Radio stations cannot be received.
Noise interferes.
A station has been preset but it can-
not be received by pressing the PRE-
SET key.
No sound from the surround speakers
RemedyCauseSymptom
Receiver, speakers
9
¢
¢
9
0
∞
∞
0
§
¡
Remote control unit
Remote control operation is not possible. ÷ Batteries are exhausted.
÷ The remote control is too far away from the
system, the controlling angle is deviated or
there is an obstacle in between.
÷ Replace with new batteries.
÷ Operate the unit inside the remote control-
lable range.
RemedyCauseSymptom
*5476/43-48/EN 04.7.27, 2:06 PM43